A small residential type Pressure Washer with a foaming Gun for easy dispensing and foaming of Car Wash Shampoo is recommended.
If in case you do not have or wish to purchase a pressure washer use a TWO BUCKET WASH SYSTEM & invest in a GRIT GUARD. Here one bucket contains your car wash shampoo and the other bucket is filled with clean water. Using this method you wash one panel at a time using your wash mitt, starting with the roof. After the panel has been washed rather than dip the mitt back into the wash bucket you first rinse the mitt in the clean water bucket rubbing it against your grit guard to remove any heavy dirt. The process is then repeated.
(RECOMMENDED) invest in an air blower to get rid of excess water from nooks, grilles, door jambs and other hard to reach areas. Also very useful in blowing of dust from the vehicle prior to cleaning.
LAMBS WOOL DUSTER
An expensive yet wise investment. Ideal to use for cleaning dust from your vehicle without having to use a micro fibre towel and risking swirls and streaking.
MICRO FIBRE DRYING TOWELS
MICRO FIBRE WATER MAGNET WAFFLE TOWELS
MICRO FIBRE PLUSH TOWELS
MICRO FIBRE FINISHING CLOTH
DO NOT WASH THE CAR; IN DIRECT SUNLIGHT, WHEN RETURNING FROM A TRIP IN THE SUN OR WHEN THE ENGINE HOOD IS HOT. IT MAY CAUSE WATERSPOTS WHEN WASHING THE CAR
Do not to use Hard (heavy in mineral content) Tap or Salty (Tanker) Water to wash your car. It may case water spots and other long term damage.
Use RO / De-ionized / Distilled Water. An easy source of distilled water is the run off from an air conditioner. You can easily collect this buy using the drain pipe of the AC unit to drip into a large water Dispenser Bottle.
Use a pressure washer (or a hose) to thoroughly rinse the car and wash of all mud and other contaminants from the vehicle.
Use the Foam gun attachment to shampoo the vehicle and use the Wash mitt to lightly scrub the vehicle thoroughly. In case of non-availability of a foaming gun, use a two bucket system and git guard to shampoo the vehicle.
Wash the cars body with your wash mitt starting from the roof and working your way down from the windscreen, boot, bonnet, doors and side panels. Remember to clean your wash mitt in the clean water bucket before re-soaking with shampoo and continuing to wash the surface Let the shampoo soak in for a few minutes then hose it down with the pressure washer or hose. Ensure complete removal of shampoo from all areas of the car.
Use the air blower to blow out water from all tight and hard to reach spots. You may also use it to run off any water beading from all over the car. Then use a varying combination of micro fibre drying towels & cloths in stages to wipe dry the entire vehicle.
Always ensure there is no dust on the vehicle when wiping dry, it may cause swirls and scratches. Always use minimal pressure and do not wipe in circles. The ceramic Pro coating on your vehicle takes care of most of the cleaning for you, so be gentle. Most importantly, take your time and do not rush the job.
Do not leave a wet car dry on its own or walk away to have a smoke or take care of some chore. Doing so may cause water spots and dust to settle.
The Ceramic Pro 9H coating does not require any waxes or detailer sprays to be applied.
1. Annual Inspections must be carried out by an approved applicator, within 30 days before or after the anniversary date of the last service to maintain the warranty.
2. Failure to undertake an annual inspection within the required period will change the period of cover to 1 Years from the date of the last service with annual inspections no longer required.
3. A fee determined by the approved applicator will be charged for the Annual Inspection which includes – Exterior Wash, Decontamination, Inspection & Ceramic Pro Sport Detailer Application.
Interior sufaces (fabric, leather, pastic, Vinyl) treated with ceramic pro products repel liquids and minimize the chance of staining & smudging. Treated surfaces require minimal maintainence.
Regular high pressure air cleaning and vacuuming will help keep the interior of the car clean and free from dirt and soiling.
Regulary use a micro fibre cloth (damp) to wipe of all treated surfaces treated.
Use any interior fabric cleaner or light apc with a micro fibre cloth (damp) to wipe of all surfaces treated with Ceramic Pro Textile.
Use any light apc or leather cleaner with a micro fibre cloth (damp) to wipe of all surfaces treated with Ceramic Pro Leather.
Use any light apc with a micro fibre cloth (damp) to wipe of all surfaces treated with Ceramic Pro Plastic/Rubber.
In case of heavy soiling or stains please visit your nearest application centre for professional stain removal treatement.